Metrohm tiamo 2.4 (process analysis) - Manual (Page 27)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1 Introduction
tiamo 2.4 (for Process Analysis)
￭￭￭￭￭￭￭￭ 11
Instruments Firmware version
890 Titrando 5.890.0022
901 Titrando 5.901.0022
902 Titrando 5.902.0022
904 Titrando 5.904.0022
905 Titrando 5.905.0022
906 Titrando 5.906.0022
907 Titrando 5.907.0022
Manual program part
￭ Dosing devices and stirrers can now be controlled in the section of the
089 Photometer.
￭ In two-channel instrument setups, it is possible to control the flash rate
for the instrument for the measuring channel.
1.10.2 Improvements
General
￭ Starting with version 2.4, tiamo also runs on Windows 8 operating sys-
tem.
￭ The installation manual now contains a description of the directories
that can be stored in a network.
￭ E-mails can now be sent simultaneously to several recipients.
￭ The Calculation algorithms ▶ Statistics chapter in the online help
has been revised.
Workplace program part
￭ For IO and stepper motor controllers, it is possible to access the inputs
from two simultaneously active workplaces, so that determinations can
proceed in parallel (was already implemented in tiamo 2.3, Patch 1).
￭ If an instrument required in the method does not exist, the message
009-032 Device not OK is displayed instead of 009-117 Device
not ok. The new message also contains the corresponding command
name, in addition to the instrument name.
￭ The determination of the transmission factor (MEAS TMF command)
has been optimized.
Database program part
￭ If a regular spectrum is measured with the Avantes spectrometer
(MEAS Spec), it is now possible to modify the evaluation areas during
the reprocessing of the determination.