Metrohm tiamo 2.4 (process analysis) - Manual (Page 1651)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
7 Devices
tiamo 2.4 (for Process Analysis)
￭￭￭￭￭￭￭￭ 1635
[Details]
Opens the Details - 'Controller type' dialog in order to edit the selected
controller.
7.20.8.1.1 General - Direct controller
This controller type represents a direct connection between a digital input
and a digital output.
The following properties can be set:
Ignore input settings
Edge delays can be set at the digital input. If desired, the controller can
react to the actual input signal instead of to the delayed edges.
Invert the output signal
The output is set to the opposite status of the input.
7.20.8.1.2 Properties - Direct controller
Dialog window Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'De-
vice type' - 'Device name' ▶ Controller ▶ [Edit] ▶ Properties - 'Controller type'
Controlled variable
Selection of the controlled variable from of all of the digital inputs of the
General input type.
Selection 'Port designation'
'Port designation'
Only digital input ports of the General input type can be selected.
Ignore input settings
on | off (Default value: off)
If this option is activated, then the settings of the input signal will be
ignored.
Control value
Selection of the control value from all of the digital outputs of the Con-
troller output type.
Selection 'Port designation'
'Port designation'
Only digital output ports of the Controller output type can be
selected.
Invert the output signal
on | off (Default value: off)
If this option is enabled, then the output signal will be inverted.