Metrohm tiamo 2.4 (process analysis) - Manual (Page 1636)

7.20 IO controller
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1620 ￭￭￭￭￭￭￭￭
tiamo 2.4 (for Process Analysis)
Entry 50 characters
Default value Device type number_#
Device type
Display or selection of the device type.
Wrapper version
Display of the version of AdsWrapper.dll.
Firmware version
Display of the SPS firmware version on the bus controller. Combined of
the bus controller firmware and the version of the bus controller program.
AdsDll version
Display of the version of AdsDll.dll.
Device serial number
Display of the serial number of the device.
Set to work
Shows the date on which the device was automatically added to the
device table.
Remarks
Remarks about the device.
Entry 1000 characters
Default value empty
7.20.3 Properties - Settings
Tab: Configuration ▶ Device ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ Settings
On the tab Settings the IP address of the controller and the controller ID
are entered.
NOTE
These parameters can only be edited when newly adding a device.
IP address
IP address the controller is actuated with, usually:
￭ 172.16.17.3 for IO controller
￭ 172.16.17.4 for stepping motor controller