Metrohm tiamo 2.4 (process analysis) - Manual (Page 61)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
2 General program functions
tiamo 2.4 (for Process Analysis)
￭￭￭￭￭￭￭￭ 45
Identifica-
tion Description Commands
.IVS Value of the input at the start of
the command. CONTROL
.LCO Loop counter = current number
of completed runs, both of
Repeat loops and of While loops LOOP, CAL
LOOP, ELT LOOP
.LP.CAx Calculated value x (1 - 3) for the
last measuring point on the mea-
suring point list DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS
(without Ref,
Spec, Opt), DOS
.LP.CHA Charge for the last measuring
point of the measuring point list
in mA s KFC, BRC
.LP.CNT Intensity of the last measuring
point of the measuring point list
in counts MEAS Opt, MEAS
Opt Conc, CAL
MEAS Opt
.LP.DME Measured value differential for
the last measuring point on the
measuring point list MET
.LP.DVT dV/dt for the last measuring point
on the measuring point list (SET,
KFT, STAT, DOS) or drift for the
last measuring point on the mea-
suring point list in µg/min (KFC,
BRC) SET, KFT, KFC,
BRC, STAT, DOS
.LP.ERC ERC for the last measuring point
in the measuring point list DET
.LP.EXx External value x (1 - 3) for the last
measuring point on the measur-
ing point list DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS
(without Ref,
Spec, Opt), DOS
.LP.GFL Gas flow value for the last mea-
suring point on the measuring
point list in mL/min MEAS T/Flow
.LP.IGE Current pulsed current for the last
measuring point in the measuring
point list in mA KFC, BRC