Metrohm tiamo 2.4 (process analysis) - Manual (Page 1317)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4 (for Process Analysis)
￭￭￭￭￭￭￭￭ 1301
Identifi-
cation Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
never been started
.FIN Command status; 1 = Command has ended at least
once, 0, invalid (variable not available) = Command has
never ended
.[VAL] Value of the command variables (optional, i.e. 'Command
name.Portname' = 'Command name.Port-
name.VAL'). The value returned corresponds to the status
of the IO port after the command is exited; 1 = active, 0
= inactive
5.6.11.3.2 DIGITAL IN - General
Tab: Method ▶ DIGITAL IN ▶ Properties... ▶ General
Command name
Name of the command.
Entry 25 characters
Device
Device name
Selection of a device from those available in the device table. The only
devices which shall be offered are those with which the command can
run.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.
Device type
Shows the device type.
Selection IO Controller | Stepping Motor Controller
Default value IO Controller