Metrohm tiamo 2.4 (process analysis) - Manual (Page 1705)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
8 Manual control
tiamo 2.4 (for Process Analysis)
￭￭￭￭￭￭￭￭ 1689
Gas type Gas flow factor
Oxygen 1.000
Nitrogen 1.000
[Start]
Switches the gas flow on. The time elapsed since the start is shown in the
status display.
[Stop]
Switches the gas flow off.
Gas flow pump
Switching the gas flow pump on the Oven Sample Processor on/off.
[Start]
Switches the gas flow pump on. The time elapsed since the start is shown
in the status display.
[Stop]
Switches the gas flow pump off.
Inert gas valve
Switching the inert gas valve on the Oven Sample Processor on/off.
[Start]
Switches the inert gas valve on. The time elapsed since the start is shown
in the status display.
[Stop]
Switches the inert gas valve off.
8.4.5 Measuring
8.4.5.1 Measuring - Overview
Program part: Manual
If a Measuring input is selected in the subwindow for the device selec-
tion, then the functions and parameters belonging to this device are dis-
played in the Functions/Parameters subwindow.
Measurement functions
The measurement functions are displayed on the following tabs:
￭ Measure
￭ Intensity
￭ Sample spectrum