Metrohm tiamo 2.4 (process analysis) - Manual (Page 1023)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4 (for Process Analysis)
￭￭￭￭￭￭￭￭ 1007
If the option not defined is selected as Device name, any device types
or device groups which are able to execute the command can be selected,
independently of the devices in the device table.
Selection 774 Oven Sample Processor | 874 Oven Sam-
ple Processor
Default value 874 Oven Sample Processor
5.6.4.8.3 MEAS T/Flow - Measuring parameters
Tab: Method ▶ MEAS T/Flow ▶ Properties... ▶ Measuring parameters
Command name
Name of the command.
Entry 25 characters
The parameters for the measuring procedure can be defined on this tab.
Measuring time
Maximum period of time for measurement.
Input range 0 - 999999 s
Default value 600 s
Measuring interval
Time interval for entering a measuring point in the measuring point list.
Input range 1 - 999999.0 s
Default value 10 s
Stop measured value Temp.
Stops when the preset measured value has been reached since the start of
the measurement. off means no stop.
Input range 50.0 - 250.0 °C
Selection off
Default value off
5.6.4.8.4 MEAS T/Flow - Evaluations
Tab: Method ▶ MEAS T/Flow ▶ Properties... ▶ Evaluations
Command name
Name of the command.
Entry 25 characters
The following additional methods for evaluation of measurement curves
can be activated and defined on this tab.