Metrohm tiamo 2.4 (process analysis) - Manual (Page 1188)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1172 ￭￭￭￭￭￭￭￭
tiamo 2.4 (for Process Analysis)
Identifica-
tion Description
.EME Final measured value (measured value after processing
of the command) in the unit of the measured value
.ENP Electrode zero point of the sensor used for the com-
mand (dimensionless)
.ETE End temperature (temperature following processing of
the command) in °C
.EVT End volume (total dosed volume at the end of the
command) in mL
.FIN Command status; 1 = Command has been ended
at least once, 0, invalid (variable not available) =
Command has never been ended
.IME Initial measured value (measured value before start
conditions are processed) in the unit of the measured
value
.ITE Initial temperature (temperature before start conditions
are processed) in °C
.LP.CAx Calculated value × (1...3) for the last measuring point
of the measuring point list
.LP.DVT dV/dt for the last measuring point in the measuring
point list (SET, KFT, STAT, DOS) or drift for the last
measuring point in in the measuring point list in µg/min
(KFC)
.LP.EXx External value × (1...3) for the last measuring point of
the measuring point list
.LP.MEA Measured value for the last measuring point in the unit
of the measured value of the measuring point list
.LP.TEM Temperature for the last measuring point of the mea-
suring point list in °C
.LP.TIM Time in s until the last measuring point in the measur-
ing point list is reached
.LP.VOL Volume for the last measuring point in the measuring
point list in mL
.MR.MRC Correlation coefficient for mean dosing rate for the
whole range