Metrohm tiamo 2.4 (process analysis) - Manual (Page 1282)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1266 ￭￭￭￭￭￭￭￭
tiamo 2.4 (for Process Analysis)
Command variables
The following command variables are generated in the method run by the
command SEND and can be used in formulas under the designation
'Command name.Variable designation':
Identifi-
cation Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
not ever been started
.FIN Command status; 1 = Command has been ended at
least once, 0, invalid (variable not available) = Com-
mand has never been ended
5.6.9.4.2 SEND - Properties
Dialog window: Method ▶ SEND ▶ Properties... ▶ SEND - 'Command name'
Command name
Name of the command.
Entry 25 characters
All the Event messages listed in the table are sent simultaneously. The
table cannot be edited directly.
NOTE
A maximum of 10 event messages can be entered.
[New]
Opens the dialog window Send event message for entering a new
event message (see Chapter 5.6.9.4.3, page 1267).
[Properties]
Opens the dialog window Send event message to edit the event mes-
sage selected in the table (see Chapter 5.6.9.4.3, page 1267).
[Delete]
Deletes the selected event message.