Metrohm tiamo 2.4 (process analysis) - Manual (Page 1426)

6.6 Subwindow Titrants/Solutions
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1410 ￭￭￭￭￭￭￭￭
tiamo 2.4 (for Process Analysis)
Entry 24 characters
Default value 'empty'
Serial number
Serial number of exchange unit. With intelligent exchange units the serial
number is read out automatically and cannot be edited.
Entry 10 characters
Default value 'empty'
Cylinder volume
Cylinder volume of exchange unit. With intelligent exchange units the cyl-
inder volume is read out automatically and cannot be edited. If in the
method you have selected a solution in a titration or dosing command
then the cylinder volume will be checked in the run.
Selection 1 mL | 5 mL | 10 mL | 20 mL | 50 mL
Default value 20 mL
Cylinder serial number
Serial number of the cylinder. It is printed on new cylinders. With intelli-
gent exchange units it is read out automatically. It can be modified at any
time, e.g. if the cylinder has to be replaced.
IEU
Entry
8 characters
Default value 'empty'
EU
Entry
10 characters
Default value 'empty'
Parameters for preparation
Configuration of the parameters which are to be used in the PREP com-
mand.
Volume
Volume to be dosed in during preparation.
Input range 0.00000 - 99,999.99999 mL
Selection Cylinder volume
Default value Cylinder volume
Cylinder volume
The whole contents of the cylinder will be dosed.
Cycles
Number of rinsing cycles during preparation.