Lenze 9400 Manual - Manual (Page 93)

Single-axis controllers
Mechanical installation
Devices in the range 2 ... 24 A (0.37 ... 11 kW)
4

93 EDS94SPP101 EN 7.1
Mounting grid
We recommend to provide the mounting plate with a grid pattern of M5 threaded holes
for attaching the devices. This preparation enables easy attachment of the devices, and the
device sizes 1, 2, ... n can thus be mounted directly adjacent to each other.

Note!
ƒ
M5 screw and washer assemblies or hexagon socket screws with washers
are permitted.
ƒ Tightening torque: 3.4 Nm / 30 lb-in.
ƒ
In the installation backplane, the screwed connection may not jut out more
than 7 mm.
9400SSP0010
Fig. 4-14 Mounting grid for installation backplane and filter of device sizes 1 ... 3
 Installation backplane without footprint filter (mains or RFI filter)
 Installation backplane with footprint filter
 Grid hole pattern for installation backplane (M5 threaded holes)
 Grid hole pattern for footprint filter (M5 threaded holes)
 Cable duct
1 ... 3 Device size, mounting holes used