Accessories (overview), Filters rfi filters for single-axis controllers, General data – Lenze 9400 Manual User Manual
Page 522
Accessories (overview)
Filters
RFI filters for single-axis controllers
9
521
EDS94SPP101 EN 7.1
General data
Conformity and approval
Approval
UR
UL508
Industrial Control Equipment, Underwriter Laboratories
(File-No. E219022) for USA and Canada
Mains data
Mains types
With grounded neutral (TT/TN systems)
Operation permitted without restrictions
Other mains types
Observe instructions for special measures in the
documentation for the basic device!
Protection of persons and equipment
Enclosure
EN 60529
IP20
Not in the wire range of the
terminals
NEMA 250
Protection against contact
to type 1
Earth leakage current
IEC/EN 61800-5-1
> 3.5 mA
Observe stipulations and safety
instructions!
Insulation resistance
IEC/EN 61800-5-1
< 2000 m site altitude: overvoltage category III
> 2000 m site altitude: overvoltage category II
Environmental conditions
Climate
Storage
IEC/EN 60721-3-1
1K3 (-25 ... +60 °C)
Transport
IEC/EN 60721-3-2
2K3 (-25 ... +70 °C)
Operation
IEC/EN 60721-3-3
3K3 (-10 ... +55 °C)
Current derating at +45 ... +55 °C: 2.5 %/°C
Site altitude
0 ... 4000 m amsl
1000 ... 4000 m amsl: current derating of 5 %/1000 m
Pollution
EN 61800-5-1
Pollution degree 2
Vibration resistance
(9.81 m/s
2
= 1 g)
Transport
IEC/EN 60721-3-2
2M2
EN 61800-2
2 ... 9 Hz: amplitude 3.5 mm
10 ... 200 Hz: acceleration resistant up to 10 m/s
2
200 ... 500 Hz: acceleration resistant up to 15 m/s
2
Operation
Germanischer Lloyd
5 ... 13.2 Hz: amplitude ±1 mm
13.2 ... 100 Hz: acceleration resistant up to 0.7 g
IEC/EN 60068-2-6
10 ... 57 Hz: amplitude 0.075 mm
57 ... 150 Hz: acceleration resistant up to 1 g
Mounting conditions
Mounting place
In the control cabinet
Mounting position
Vertically
Free space
The required free space results from the mounting position
and the specifications of the standard device.
Mounting position
Standard
Footprint mounting; standard device is screwed on the filter
Variant
Side-by-side mounting; filter is directly screwed to the left of
the standard device (Mechanical installation)