Lenze 9400 Manual - Manual (Page 561)

Accessories (overview)
General accessories
Shield mounting
9

559 EDS94SPP101 EN 7.1
Select the shield mounting according to the cable characteristics.
Lenze system cables EMC clip EMC wire clamp Cable tie
a
[mm 2 ]
d
[mm]
EZA...
(spring clip)
E94AZJS003
(C02)
E94AZJS007
(C03)
E94AZJS024
(C04)
EZAMBKBM
(metallic)
standard, shielded
1.0 10.3 • • • - •
1.5 11.6 • • • - •
2.5 13.2 - • • - •
4.0 14.5 - • • • •
6.0 16.5 - - • • •
10 19.6 - - • • •
suitable for trailing
1.0 11.2 • • • - •
1.5 12.3 - • • - •
2.5 14.2 - • • - •
4.0 14.8 - • • • •
6.0 17.5 - - • • •
10 20.5 - - - • •
Tab. 9-6 Cable characteristics of Lenze system cables
a
Single-core cross-sections of a Lenze system cable (motor)
Standard design or trailing cable
d Cross-section of Lenze system cable/cable shield

Tip!
If a shield mounting cannot be used because of thicker cables, in many cases,
an alternative is possible.
Instead of the EMC clip you can e.g. use the EMC wire clamp E94AZJS003 or the
metallic cable tie EZAMBKBM.