Lenze 9400 Manual - Manual (Page 179)

Multi-axis controllers
Mechanical installation
Important notes
5

179 EDS94SPP101 EN 7.1
Mounting grid
We recommend to provide the mounting plate with a grid pattern of M5 threaded holes
for attaching the devices. This preparation enables easy attachment of the devices, and the
device sizes 1, 2, ... n can thus be mounted directly adjacent to each other.

Note!
ƒ M5 screw and washer assemblies or hexagon socket screws with washers
are permitted.
ƒ Tightening torque: 3.4 Nm / 30 lb-in.
ƒ In the installation backplane, the screwed connection may not jut out more
than 7 mm.
SSP94PN010
 Mounting with backplane for attaching the power supply module
 Grid hole pattern for installation backplane
 Grid hole pattern for other device sizes or built-on/footprint filters (only Single Drive)
 Cable duct
1
...
3
Device size, mounting holes used