Lenze 9400 Manual - Manual (Page 465)

Accessories (overview)
Motor holding brake control modules
Motor holding brake control module E94AZHY0026
9

465 EDS94SPP101 EN 7.1
Installation steps
E94AZHY003
1. Plug the motor brake control module onto the terminals  of the standard device.
– Ensure that both clips  snap into the slots  of the standard device!
2. Check that the motor brake control module is securely connected.
Terminal data
Terminal X107 Labelling Description
Connection of the motor holding brake:
BD1
BD2
+ (Lenze: WH)
- (Lenze: BN)
E94AZHY0026: 180 V DC, max. 0.61 A
Ensure correct polarity!
SSP94A6107
L1
L2/N
Supply voltage of the motor holding brake
Terminal data
Conductor cross-section Tightening torque
[mm 2 ] [AWG] [Nm] [lb-in]
Flexible
0.5 ... 2.5 20 ... 12 Spring terminal With wire end
ferrule
Stripping length or contact length: 8 mm