Lenze 9400 Manual - Manual (Page 113)

Single-axis controllers
Wiring
Devices in the range 2 ... 24 A (0.37 ... 11 kW)
4

113 EDS94SPP101 EN 7.1
Motor temperature monitoring
Terminal X106 Labelling Description
T1
T2
Motor temperature monitoring with PTC element (type-A sensor,
switching performance according to EN 60947-8 for type-A tripping
units) or thermostat (NC contact).
SSP940X106
Terminal data
Max. conductor cross-section Tightening torque

[mm 2 ] [AWG] [Nm] [lb-in]
Flexible
2.5 12 0.5 ... 0.6 4.5 ... 6.2 PZ0
With wire end ferrule
Motor brake control (optional)

Note!
When the 24 V supply voltages (at X2) are applied and a motor holding brake
is available, the devices respond as follows:
ƒ SingleDrive without mains or DC-bus voltage: The motor holding brake
cannot
be released.
ƒ MultiDrive without DC-bus voltage: The motor holding brake can be
released.

Tip!
For detailed information on the motor holding brake control modules, please
see the chapter Accessories ( 419).
For information on the E94AZHX0051 motor holding brake control module
optionally contained in the installation backplane, please see the chapter
Accessories starting on page 420.
Terminal X107 Labelling Description
Connection of the motor holding brake
BD1
BD2
+ (Lenze: WH)
- (Lenze: BN)
E94AZHX0051: 24 V DC, max. 2.5 A
Observe correct polarity!
+ / - Supply voltage for the motor holding brake (18 ... 30 V DC)
Observe correct polarity!
SSP940X107