Lenze 9400 Manual - Manual (Page 264)

Regenerative power supply modules
General data and operating conditions
7

264 EDS94SPP101-7.1
Mounting conditions
Mounting place
In the control cabinet
Mounting position Vertical
Mounting clearances
Above/below ≥ 80 mm / ≥ 120 mm
Observe the device-related
notes on mounting.
To the sides Side-by-side mounting without
any clearance
Supply conditions for the regenerative power supply module
AC mains operation
Connection at the assigned mains filter
DC-bus operation Direct connection of the axis modules via terminals or
busbar systems
See the chapter on DC-bus operation in the Hardware
Manual for further information.
Environmental conditions
Climate
Storage IEC/EN 60721-3-1 1K3 (-25 ... +60 °C)
Transport IEC/EN 60721-3-2 2K3 (-25 ... +70 °C)
Operation IEC/EN 60721-3-3 3K3 (-10 ... +55 °C)
Current derating at +45 ... +55 °C:
Device size 1 ... 7: 2.5 %/°C
Device size 8S ... 10: 1 %/°C
Site altitude 0 ... 4000 m amsl
1000 ... 4000 m amsl: current derating of 5 %/1000 m
Pollution EN 61800-5-1 Degree of pollution 2
Vibration resistance (9.81 m/s 2 = 1 g)
Transport IEC/EN 60721-3-2 2M2
EN 61800-2 2 ... 9 Hz: amplitude 3.5 mm
10 ... 200 Hz: acceleration resistant up to 10 m/s
2
200 ... 500 Hz: acceleration resistant up to 15 m/s 2
Operation Germanischer Lloyd 5 ... 13.2 Hz: amplitude ±1 mm
13.2 ... 100 Hz: acceleration resistant up to 0.7 g
IEC/EN 60068-2-6 10 ... 57 Hz: amplitude 0.075 mm
57 ... 150 Hz: acceleration resistant up to 1 g