INFICON Cygnus 2 Thin Film Deposition Controller - Manual (Page 52)

3 - 2
IP
N 07
4-
54
5-
P1
E
Cygnus 2 Operating Manual
4 System Switches
An array of three keys that provide START, STOP ALL and RESET for process
control.
START: Starts the cursored Material if in Ready, Idle or Stop and Start Interlock
is not in effect.
RESET: Places the cursored Material in Stop into the Ready mode.
STOP ALL: Places all Materials into the Stop mode.
5 Handheld Controller Mount
Tapped hole for attaching support bracket.
6 F1, F2, F3, F4 Function Keys
The function keys. They are used to select displays or menu items. Their
function is indicated on the display and is described in subsequent sections.
7 USB
Receptacle for a storage device.
8 Remote Control Jack
Receptacle for the optional wired Handheld Controller (IPN 750-262-G1). For
more information on the
Handheld Controller, see section 3.5.5 on page 3-31 .
9 Cursor Keys
An array of five keys used to move the display cursor either up, down, left or
right. The MENU key is used to navigate through the Cygnus 2 displays. The
keys auto-repeat; the cursor will continue to move as long as the key is held
down.
10 Power
This switch controls secondary power to the Cygnus 2 between ON and
STANDBY.
11 Pilot Light
A green light, adjacent to the power switch, illuminated when secondary power
is on.