INFICON Cygnus 2 Thin Film Deposition Controller - Manual (Page 224)

13 - 8
IP
N 07
4-
54
5-
P1
E
Cygnus 2 Operating Manual
USB (File Check Sum)
Error: Data Corrupt The message is
removed from
the screen on
any key press or
if another
transient
message
appears Storage 25
USB error: Bad Conf.
File Storage 26
USB DataLog Fast Out
Error 27
USB Error (generic) USB Interface system error All 28
(USB: Conf. file:)
Structure Version
Change Structure version updated because of the
new configuration. Storage 29
(USB:) Parameter Value
Changed Parameter value has been adjusted during
the Range Check verification procedure. Storage 30
USB Busy Any key is pressed while the USB is busy. All 31
(USB:) No Such File
(Available) Attempt to access non- existing or folder
non-specific file. Storage 32
(USB: Too many files)
Archive Old Files Too many files in a directory All 33
Logic Edit In Progress Key press (STOP,RESET,START, MENU)
while in logic edit mode: Logic Edit 53
No Paren on Empty
Term Parentheses are not allowed on an empty
term. Logic Edit 54
No Left Paren on Last
Term. Cannot insert Left (opening) parenthesis
on the last term. Logic Edit 55
Select an Event to Edit Attempt to edit a non-event assigned label. Logic Edit 56
Select an Action to Edit Attempt to edit a non-action assigned label. Logic Edit 57
Select an Event to
Delete Attempt to delete a non-event assigned
label. Logic Edit 58
Select an Action to
Delete Attempt to delete a non-action assigned
label. Logic Edit 59
Max Terms: Cannot
Insert An attempt was made to enter an equation
with more then the allowed event or action
terms. Logic Edit 60
Cannot Negate Empty
Term Attempt to negate an empty term. Logic Edit 61
Meas. Board Comm
Error Bad communications with the meaurement
card. All 62
No Switch: No XIU No XIU attached, cannot do a switch. All 63
Table 13-4 Transient messages (continued)
Transient Message Set Clear Screen Remote
Comm.
Encodes