INFICON Cygnus 2 Thin Film Deposition Controller - Manual (Page 225)

13 - 9
IP
N 07
4-
54
5-
P1
E
Cygnus 2 Operating Manual
In Crucible Switch An attempt was made to navigate or
change a parameter in the Source
Maintenance screen while a crucible
switch was in process. The message is
removed from
the screen on
any key press or
if another
transient
message
appears Source
Maintenance
* Not
available
Maintenance Enabled An attempt was made to leave a
Maintenance screen while Source
Maintenance was enabled Source
Maintenance Not
available
from
Remote
Comm
Crucible Switch Fail Crucible switch fail while in Source
Maintenance. Source
Maintenance Not
available
from
Remote
Comm
* Remote communications are not permitted while in Source Maintenance.
Power Loss Post Power cycle Operate 69
Table 13-4 Transient messages (continued)
Transient Message Set Clear Screen Remote
Comm.
Encodes