Local i/o, Local dmx outputs, Show control gateway – ETC Element v2.1.0 User Manual
Page 267
B
Element Configuration Utility
255
Local I/O
This screen allows you to configure the ports on the back of the Element desk.
Local DMX Outputs
The following settings are available:
• Enable - enables DMX output from the local ports.
• Default Output Protocol - enables DMX as a default output.
• Ports - the settings for the two DMX ports.
•
Address - sets the starting address for the port.
•
Doubled - enables dimmer doubling on the port.
•
Speed - sets the speed for the ports. Options are: maximum, fast, medium, and slow.
The speed may need to be adjusted for certain devices. The default speed is maximum.
• Dimmer Doubled Offset - this offset matches the default offset in CEM+ / CEM3 when
configuring your Sensor dimmer rack for dimmer doubling. The default offset is 20,000.
Show Control Gateway
Group IDs
Allows you to set the group number for the MIDI In and MIDI Out ports. Group numbers can be from
1-32. Default for both ports is 1.
Contact Closure (remote trigger connector)
Allows you to set the Group and Address In values for the remote trigger input on the back of
Element.
N o t e :
To input RS-232 into an Element desk, you will need to use a Net3 I/O Gateway.