About macros, Store a macro from live, Using the [learn] key – ETC Element v2.1.0 User Manual
Page 220
208
Element User Manual
About Macros
Macros are a recorded series of button presses (both hard and softkeys), screen commands and
events. Macros can be used to simplify complex or repetitive console programming and operating
tasks that you perform often.
When you record the series of button presses to a new macro, you can later play it back by
triggering it manually, pressing the macro direct select button, running it from a linked cue,
accessing it from a connected show control system, remotely triggering the macro, or running it
from another recorded macro.
You may create up to 1,000 macros either from the live display using the macro [Learn] mode to
record a sequence of keystrokes as you perform the operation, or you can create a macro within the
macro editor display, entering and editing keystrokes into the macro content editor without actually
executing the instructions.
The macro editor display contains a listing of all recorded macros including labels and the contents
of the macros stored. All macro editing is accomplished from the macro editor display.
Store a Macro from Live
The most direct way to store a macro is from live mode using the macro [Learn] mode to record a
sequence of button presses as you enter them. You can include any button press on the console
(hard key or soft key), except [Macro], the arrow keys, [Escape], [Select], and [Learn].
Using the [Learn] key
Pressing the [Learn] key while in live mode places the console in macro learn mode. The [Learn]
key flashes and the CIA displays “Learning” above the command line. Assign a number identifier
(from 1 to 1000) to the Macro using the control keypad and press [Enter]. The CIA flashes
“Learning Macro ####” above the command line. This indicates that the console is ready to record
the macro.
N o t e :
It is helpful if you plan your macro content in advance of the macro record process.
While in learn mode, each button press is recorded as content, even the [Clear]
button if you have mistaken a keystroke. There is no way to fix a content error
while learning the macro in live, but you can rerecord the macro as needed or you
can edit the recorded macro in the macro editor, removing any unneeded
commands.