Park values from the park display – ETC Element v2.1.0 User Manual
Page 208
196
Element User Manual
Park Values from the Park Display
You can park and unpark channel parameters or addresses from the park display. Open the display
by pressing [Park]. While in this display, it is assumed that you want to park channels or
parameters, therefore the use of the {Park} softkey is not necessary when parking, but is used for
unparking. You can also use [At] [Enter] to unpark.
Following are examples for parking channel parameters from the park display:
• [3] [At] [4] [5] [Enter] - parks channel 3 at 45%.
• [3] {Color Palette} [4] [Enter] - parks color for channel 3 at color palette 4.
Following are examples for clearing parked values while in the park display:
• [channel list] {Park} [Enter] - unparks channels in the list.
• [channel list] [At] [Enter] - unparks channels in the list.
Below are examples for parking addresses in the park display:
• [Dimmer/Address] [5] [At] [5] [0] [Enter] - parks address 5 at 50% intensity.
• [Dimmer/Address] [5] [At] [Enter] - unparks address 5.
When parking a range of addresses in the Park display, using [Thru] will only park the intensities.
If you want to park all of the addresses and parameters within the selected range, you will need to
use [Thru] [Thru].
• [Dimmer/Address] [5] [Thru] [2] [5] [Enter] - parks only the intensities of addresses 5 thru
25.
• [Dimmer/Address] [5] [Thru] [Thru] [2] [5] [Enter] - parks all of the parameters of addresses
5 thru 25.
Parked addresses
Parked channels