Flash, Moving light control – ETC Element v2.1.0 User Manual

Page 108

Element User Manual

Flash

Using the {Flash} softkey in Live will alternate the intensity level for selected channels or addresses
between full and 15% output every second. The channel or address will keep flashing until either
the command line is cleared, or [Next]/[Last] is used to increment to the next channel or address.

• [1]{Flash} - will flash intensity for channel 1.

• [Next] - channel 1 returns to its previous state and the intensity for channel 2 will flash.

• [Dimmer/Address] [1][0]{Flash} - will flash intensity for address 10.

You can also use [Shift] & [Full] and [Shift] & [Out] to briefly flash levels. While [Shift] & [Full] is
depressed, selected channels will be held at full. While [Shift] & [Out] is depressed, selected
channels will be held at zero.

Moving Light Control

For more information about the ML Control display, see

Moving Light Control, page 146

. For more

information on programming moving lights, please see the

Element tutorials

http://