ETC Element v2.1.0 - Manual (Page 167)

12
Using Moving Lights and Palettes 155
Editing Palettes Live
Rerecord
Rerecording follows the conventions illustrated in the [Record] and [Record Only] sections
detailed earlier in this chapter. The only exception is that a confirmation is required to record over
an existing palette.
There are two different methods for rerecording:
• [Record] [Palette] [5] [Enter] [Enter] - overwrites the content completely.
• [Channel List] [Record] [Palette] [5] [Enter] [Enter]- merges the data.
Update
Live changes can be updated to both active and inactive palettes. When updating a parameter in an
active palette, that parameter will no longer be absolute data, but will now be in the updated palette
on stage.
The following illustrates how to update color palette 2 when no cues are active and you have
recalled channels within that palette.
• <channel list> [Update] {Color Palette} [2] [Enter] - any manual changes for channels
originally in the palette are updated in color palette 2.
• [1] [Update] {Color Palette} [2] - adds channel 1’s manual data to color palette 2.
If a channel or parameter does not have data in the palette being updated, it will not be added to
that palette unless the user specifically requests it by specifying the channel.
N o t e : If a palette is already recorded, [Record] replaces all existing data, unless
selective store is used. [Record Only] is a selective store, therefore it adds data.
Recording over a previously existing palette requires a confirmation, if
confirmations are enabled in the setup menu.
It is also possible to [Update] to add manual changes to the record target.