HP Neoview Release 2.5 Software - Manual (Page 151)

4. Modify the information in these tabs, as necessary:
• “Use the General Properties Tab” (page 143) .
NOTE: You must change the data source name. If you do not change the name, HPDM
returns an error message indicating that the data source already exists.
• “Use the DEFINEs and SETs Tab” (page 147)
• “Use the Control Query Defaults Tab” (page 148)
• “Use the Controlled Tables Tab” (page 149)
NOTE: If you made changes to the values in a tab, but you did not apply the changes, you
can revert to the values previously stored on the server by clicking [ Reload ].
5. Click [ Create ].
Terms
operator privilege
data source
Start a Data Source
Requirement: Only roles that have OPERATOR privileges can perform management tasks.
When you start the NDCS service, data sources configured with the automatic startup option
are started. You cannot start the Admin_Load_DataSource. This data source is always started
so that HPDM can continue managing connectivity when all other data sources are stopped.
To start a data source:
1. Verify that the association server for the data source is started:
a.
Check the NDCS Server Status display for the data source by performing the steps in
“Display NDCS Services” (page 157) .
b. If the association server ($MXOAS or $MXAS2) is not available, start it by following
the steps in
“Start an NDCS Service” (page 158)
2. In the left navigation pane, click the data source that you want to start.
3. In the right pane, click the Data Source Status tab to display the list of services.
4. Select the association server Service Name that you want to use with the data source.
NOTE: For optimal performance, always use MXAS2 with the Transporter data source
and MXOAS with other data sources. For more information about association servers, see
“Learn About the Association Servers” (page 156) .
5. Click [ Start ].
Terms
operator privilege
association server
data source
Stop a Data Source
Requirement: Only roles that have OPERATOR privileges can perform management tasks.
You cannot stop the Admin_Load_DataSource. This data source is always started so that HPDM
can continue managing connectivity when all other data sources are stopped.
To stop a data source:
1. Under the navigation tree pane, click the Connectivity area.
Start a Data Source 151