HP Neoview Release 2.5 Software - Manual (Page 101)

NOTE: The [ Change Password ] button is active only if you have sufficient privileges to
change the password for the selected role.
6. Fill in the fields in the dialog box, and click [ OK ]. For more information about the dialog
box fields, see
“Use the Change Role Password Dialog Box” (page 101) .
Related Topics
“Use the Change Role Password Dialog Box” (page 101)
Terms
power role
Use the Change Role Password Dialog Box
This table describes the fields in the Change Role Password dialog box:
Description Field
Shows the name of the selected role. Role Name
Type the current password. This field is enabled only if the security policy for the system
requires it. Old Password
Type the new password. The password can consist of a maximum of 53 characters if
you use 1024-bit encryption, or 64 characters if you use 2048-bit encryption. New Password
Type the exact same password as you typed in the New Password field. Confirm New Password
Select this option to set a password that does not expire. HP recommends that role
passwords have no expiration. No Expiration
Select this option to configure an expiration interval (Expires Every n Days) or date
(Expiry Date date) for the password. Use Expiration
Enter the number of days, from the time the password is changed, after which it expires.
Any integer value is valid. Expires Every n Days
Enter the date on which the password expires. To enable the date field, click the check
box to the left of the date. Then specify a date. If you do not click the check box, the
Expiry Date
field is disabled.
Expiry Date date
Related Topics
“Change the Password or Expiration for a Role” (page 100)
Use the Change Role Password Dialog Box 101