HP Hitachi Dynamic Link Manager Software - Manual (Page 396)

8. Messages
372
Action
Check whether the HDLM driver has started normally. If it has not started or
contains an error, contact your HDLM vendor or the maintenance company, if
there is a maintenance contract for HDLM, and report the error and detail code.
KAPL05012-I
The device (
aa...aa
) for Disk (
bb...bb
), Partition (
cc...cc
) is selected
for a mounted drive.
Details
The device object corresponding to the disk (bb...bb: Disk sequence number
(decimal (base-10) number)), partition (cc...cc: Partition sequence number
(decimal (base-10) number)), and device object address (aa...aa: Device object
address (hexadecimal number)) is the first path for the LU (including the
non-HDLM target device).
Action
None.
KAPL05013-I
The device (
aa...aa
) for Disk (
bb...bb
), Partition (
cc...cc
) was removed
from the mounted drive.
Details
The device object corresponding to the disk (bb...bb: Disk sequence number
(decimal (base-10) number)), partition (cc...cc: Partition sequence number
(decimal (base-10) number)), and device object address (aa...aa: Device object
address (hexadecimal number)) is the second or a subsequent path for the LU.
Action
This is normal. If the target drive cannot be referenced, check the disk
configuration.
KAPL05014-I
The device object (
aa...aa
) was registered as the path (
bb...bb
).
Details
The path (bb...bb: Core logic path identifier (hexadecimal number)) of the device
object (aa...aa: Filter driver management table address (hexadecimal number))
was successfully registered into the core logic.
Action
None.
KAPL05032-I
The path health checking for the path (
aa...aa
) completed normally.
(
bb...bb
,
cc...cc
)