HP Hitachi Dynamic Link Manager Software - Manual (Page 276)

6. Command Reference
252
#2
The EMC DMX series and the HP EVA series cannot be managed.
-t
Does not display the title for each information item.
Example
>dlnkmgr view -stinfo
EMC Symmetrix DMX Series, CLARiiON CX Series : on
HP StorageWorks EVA Series : on
KAPL01001-I The HDLM command completed normally.
Operation name = view, completion time = yyyy/mm/dd
hh:mm:ss
>
(3) Parameters Used When Displaying Path Information
When displaying path information, if you specify either the
-item
or
-c
parameter
and also specify the
-path
parameter, you can select the items to display and display
a summary of path information. This section describes each parameter, path
information and displayed items.
Parameters to display path information:
-path
When you specify the
-path
parameter and do not specify either the
-c
or
-item
parameter, the information will be displayed about the HDLM managed paths
without abbreviating or selecting items.
In the sub-parameters (following
-path
), you can filter the paths to be listed
using
-hdev
and sort the list using
-srt
. When you omit both parameters, the
command displays information for all the paths in order of ascending
AutoPATH_IDs.
For details on what is displayed in each item, see Table 6-13: Displayed Path
Information.
AutoPATH_IDs displayed by the
-path
parameter depend on the sequence in
which HDLM detects the paths after a host is started up. Because of this, make
sure that you use the path name
PathName
to identify a path.
The sub-parameters are as follows:
-hdev
host-device-name
Displays information only for the paths accessing the specified host device.
Specify a drive letter to indicate the desired host device. You cannot specify