HP Hitachi Dynamic Link Manager Software - Manual (Page 345)

8. Messages
321
aa...aa:
view
Action
Execute the
view
operation of the HDLM command (
dlnkmgr view -path
) to
check the value displayed in
HDevName
. Specify a host device for the value of
HDevName
, and then retry. For details on the
view
operation, see 6.7 view
(Displays Information).
KAPL01019-W
The target path was not found. Operation name =
aa...aa
Details
aa...aa:
offline
,
online
, or
view
•
offline
/
online
operation
The specified path does not exist.
•
view
operation
The paths have not been configured because creation of the HDLM
environment or configuration changes to the HDLM operating environment
have not finished.
Action
•
offline
/
online
operation
Use the
view
operation of the HDLM command (
dlnkmgr
) to check the
settings, and then retry. For details on the
view
operation, see 6.7 view
(Displays Information).
•
view
operation
Refer to 3. Creating an HDLM Environment. Creating an HDLM
Environment or 4.7 Reconfiguring the HDLM Operating Environment, and
then configure any paths that exist. If the same message appears again,
execute the
DLMgetras
utility for collecting HDLM error information,
acquire the error information, and then contact your HDLM vendor or the
company for which you have a service contract. For details on the
DLMgetras
utility, see 7.2 The DLMgetras Utility for Collecting HDLM
Error Information.
KAPL01021-E
Cannot execute the HDLM command due to insufficient memory.
Details
Memory required for HDLM command processing could not be allocated.
Action