HP Hitachi Dynamic Link Manager Software - Manual (Page 245)

6. Command Reference
221
Specify the host port number and bus number of the target HBA port: the numbers
are found in the
PathName
field displayed using the
view
operation. Enter a
period between these two parameter values. For details about the
view
operation,
see 6.7 view (Displays Information). Leading zeros of each parameter value can
be omitted; however, when the host port number or bus number of the target HBA
port is
0000
, enter
0000
or
0
for the corresponding parameter value.
Example
The following example shows how to place online all paths connected to an
HBA port whose host port number is
0001
and bus number is
0001
:
>dlnkmgr online -hba 1.1
KAPL01057-I All the paths which pass the specified HBA
will be changed to the Online status. Is this OK? [y/n]:y
KAPL01061-I 3 path(s) were successfully placed Online; 0
path(s) were not. Operation name = online
>
-cha -pathid
AutoPATH_ID
Use this parameter to place online, at one time, all the paths that pass through a
specific channel adapter port. The command will place online all the paths that
pass through the channel adapter port to which the path with the specified
AutoPATH_ID is connected. You can specify this parameter only when the
HDLM management-target device is the Thunder 9500V series, Lightning 9900
series, Lightning 9900V series, Hitachi USP, Hitachi AMS2000/AMS/WMS/
SMS series, Universal Storage Platform V/VM, and Virtual Storage Platform.
Specify the current AutoPATH_ID of the target path, which is displayed by using
the
view
operation. For details about the
view
operation, see 6.7 view (Displays
Information). Leading zeros can be omitted (
000001
and
1
indicate the same
AutoPATH_ID); however, when the target AutoPATH_ID is
000000
, enter
000000
or
0
for the parameter value.
AutoPATH_IDs are re-assigned every time the host is restarted. Always make
sure that you use the
view
operation to find the current AutoPATH_ID of the
target path, before executing the
online
operation.
Example
The following example shows how to place online the paths connected to the
channel adapter port
0A
. In this example, a path whose AutoPATH_ID is
000002
is connected to the target channel adapter port:
>dlnkmgr online -cha -pathid 000002
KAPL01057-I All the paths which pass the specified CHA
port will be changed to the Online status. Is this OK?
[y/n]:y