HP Hitachi Dynamic Link Manager Software - Manual (Page 204)

4. HDLM Operation
180
For details on the displayed items and their descriptions, see 6.7 view (Displays
Information).
4.3.8 Updating the License
This section explains how to update the license.
To update the license, execute the
dlnkmgr
command's
set
operation with the
-lic
parameter specified. When the confirmation message is displayed, enter
y
to execute,
or
n
to cancel the command. If the license key file does not exist, a message asking you
to enter the license key appears, so enter the license key.
Note:
When you are executing the
dlnkmgr
command's
set
operation with the
-lic
parameter to install the license, you can only execute it once at a time. If you
attempt to execute more than one
dlnkmgr
command containing the
set
operation with the
-lic
parameter, the following message might appear and
HDLM might terminate abnormally:
KAPL01075-E A fatal error occurred in HDLM. The system
environment is invalid.
If this message appears, execute the
dlnkmgr
command's
view
operation with
the
-sys -lic
parameter to make sure that the license is installed correctly.
The following shows an example in which the command is executed:
>dlnkmgr set -lic
KAPL01049-I Would you like to execute the operation? Operation
name = set [y/n]: y
KAPL01071-I A permanent license was installed.
>
4.3.9 Viewing HDLM Version Information
This section explains how to display HDLM version information.
To display HDLM version information, execute the
dlnkmgr
command's
view
operation with the
-sys
parameter specified. The following shows an example in
which the command is executed:
>dlnkmgr view -sys
HDLM Version : x.x.x-xx
Service Pack Version :
Load Balance : on(extended lio)
Support Cluster : off
Elog Level : 3
Elog File Size (KB) : 9900
Number Of Elog Files : 2
Trace Level : 0