HP Hitachi Dynamic Link Manager Software User Manual

Page 130

3. Creating an HDLM Environment

106

The program checks whether HDLM has already been installed. If HDLM

5.4 or earlier has been installed, the KAPL09129-E message will appear. If

this happens, carry out the procedure shown in 3.5.6 Migrating from HDLM

5.4 or Earlier to HDLM 5.5 or Later. If HDLM 5.5 or later has been

installed, the KAPL09173-W message will appear. If this happens, carry out

the procedure shown in 3.5.5 Upgrade Installation or Re-installation of

HDLM. If no message appears, go to step 6.

• If you are planning to perform an unattended installation, execute the

installhdlm

utility.

At the command prompt, execute the following command:
drive-to-which-the-installation-DVD-is-inserted

:\HDLM_Windows\DLMTo

ols\installhdlm -f

installation-information-settings-file

Specify

for the

restart

key in the installation-information settings file.

This command checks whether HDLM has already been installed. If HDLM

5.4 or earlier has been installed, the KAPL09129-E message will appear. If

this happens, carry out the procedure shown in 3.5.6 Migrating from HDLM

5.4 or Earlier to HDLM 5.5 or Later. If HDLM 5.5 or later has been

installed, the KAPL09183-E message will appear, and then the upgrade

installation or re-installation will be performed.
After the installation is complete, go to step 13.

The program checks the MPIO driver version, and then installs the MPIO driver.

If a message appears asking you whether you want to install the MPIO driver,

make sure that no multi-path management software other than HDLM is installed.

• If multi-path management software other than HDLM is installed, click the

Cancel button to cancel the installation, uninstall the multi-path

management software, and then install HDLM.

• If no multi-path management software other than HDLM is installed, click

the Next button to continue the installation.

Specify a license key file or enter a license key by following the instructions

shown in the messages that appear in the window.

• If a license key file was saved in step 4, specify that license key file.
• If a license key file is not being used, specify the license key directly.

Specify the installation folder by following the instructions shown in the

messages that appear in the window.
The utility for registering HDLM persistent reservation keys (

dlmprsvkey

) will

be automatically executed. However, creation of the PRSV key might be

unsuccessful if, for example, an NIC does not exist. If the PRSV key is created