HP Hitachi Dynamic Link Manager Software - Manual (Page 146)

3. Creating an HDLM Environment
122
• The PRSV key will be registered before the installation finishes. If the
KAPL09131-W message appears, follow the procedure described in step 9.
• Although a message prompting you to restart the host appears after the
installation has finished, a restart is not necessary.
• In the last installation window, the following message might be output:
When you manage a host by using Global Link Manager and
Windows firewall is enabled on that host, execute the
firewall_setup command to allow a firewall exception.
If Global Link Manager will not be used to manage HDLM, you do not need
to take any action.
To manage HDLM with Global Link Manager, register Firewall exceptions.
For details, see 3.5.8 Firewall Settings for Managing HDLM by Using
Global Link Manager.
8. Check the results of the installation.
If you have performed an unattended installation, check the installation results
from the command prompt.
9. After the installation finishes, execute the
dlmprsvkey
utility with the
-v
parameter specified.
Execute the following command:
HDLM-installation-folder
\bin\dlmprsvkey -v
Make sure that the PRSV key displayed by the
dlmprsvkey
utility is unique
among all the hosts in the SAN. If the PRSV key is not unique or not registered,
or if the KAPL09131-W message appears, execute the
dlmprsvkey
utility with
the
-r
parameter specified to re-register the PRSV key. If the PRSV key is
unregistered, HDLM functions might not properly operate. For details about the
dlmprsvkey
utility, see 7.4 The dlmprsvkey Utility for Registering an HDLM
Persistent Reservation Key. If you used a license key file, it will be deleted after
the installation finishes. The KAPL09115-W message will appear if deletion of
this file fails. If this happens, delete the file manually.
10. If you want to select an EMC CX series LU as the HDLM management-target
device, perform the following steps to register it. Otherwise, go to step 15.
11. From Control Panel, choose MPIO.
The MPIO Properties dialog box opens.
12. On the MPIO-ed Devices page, click the Add button.
The Add MPIO Support dialog box opens.
13. For Device Hardware ID, enter
DGC RAID
, and then click the OK button.