HP Hitachi Dynamic Link Manager Software - Manual (Page 248)

6. Command Reference
224
>
Reference
Using the
view
operation together with Windows commands enables you to filter the
path information listed for a specific HBA port or channel adapter port. For details
about the
view
operation, see 6.7 view (Displays Information).
We recommend that you use the following command and verify the information on the
target paths before you execute the
online
operation to place online all the paths
connected to a specific HBA port or channel adapter port.
Example 1
The following example shows how to filter and display the information on all
paths that pass through the HBA port whose host port number is
0004
and bus
number is
0001
:
>dlnkmgr view -path | find "0004.0001"
The above command will display information on all the paths that pass through
the specified HBA port.
Example 2
The following example shows how to filter and display the information on all
paths that pass through the channel adapter port
0A
of the Thunder 9500V Series:
>dlnkmgr view -path -stname | find "9500V" | find "0A"
The above command will display information pertaining to only those paths that
pass through the specified channel adapter port.
Note:
When the LU dynamic deletion function is used, a path might be deleted due to an
error. If this happens and you attempt to change the path status, an error will occur.
Confirm that the path, which you attempt to change the status of, has been deleted, and
then resolve the path error. For details, see 4.7.2 Deleting an LU Dynamically.