HP Hitachi Dynamic Link Manager Software - Manual (Page 167)

3. Creating an HDLM Environment
143
To check the current audit log settings, execute the following command:
>dlnkmgr view -sys -audlog
Audit Log : off
Audit Log Category : -
KAPL01001-I The HDLM command completed normally. Operation name
= view, completion time = yyyy/mm/dd hh:mm:ss
>
3.7.2 Setting Up the HDLM Functions
The recommended and default values for each HDLM function is shown below in
Table 3-14: The Recommended and Default Values for Each Function.
Table 3-14: The Recommended and Default Values for Each Function
Function Default value Recommended value
Load-balancing on
The Extended Least I/Os algorithm is
used. on
The recommended algorithm depends
on the operating environment.
Path health checking on
30-minute check interval on
The recommended checking interval
depends on the operating
environment.
Automatic failback on
1-minute check interval The recommended checking interval
depends on the operating
environment.
Intermittent Error Monitor off off
Remove LU off off
Logging level 3: Collects all the error information for
the "Information" level or higher 3: Collects all the error information for
the "Information" level or higher
Trace level 0: Do not output trace files 0: Do not output trace files
File size for the Error log 9900 (KB) 9900 (KB)
Number of files for the Error
logs
2 2
File size for trace information 1000 (KB) 1000 (KB)
Number of files for trace
information
4 4
Collection of audit log data off Set
on
, if you want to collect audit log
data.