HP Hitachi Dynamic Link Manager Software - Manual (Page 142)

3. Creating an HDLM Environment
118
If you used a license key file, it will be deleted after the installation finishes. The
KAPL09115-W message will appear if deletion of this file fails. If this happens,
delete the file manually.
16. Shut down the host.
Leave the host in a single-path configuration until you check (in step 24) whether
HDLM has been successfully installed.
17. On all the hosts that make up the cluster system, perform steps 3 to 16.
18. Make sure that all the hosts that make up the cluster system have been completely
shut down.
19. Restart each host.
20. Log on to Windows again as a member of the Administrators group.
21. Make sure that the program is running properly, by examining the results of the
dlnkmgr
command's
view
operation.
An example of executing the
dlnkmgr
command's
view
operation is as follows:
>dlnkmgr view -sys
HDLM Version : x.x.x-xx
Service Pack Version :
Load Balance : on(extended lio)
Support Cluster : off
Elog Level : 3
Elog File Size (KB) : 9900
Number Of Elog Files : 2
Trace Level : 0
Trace File Size(KB) : 1000
Number Of Trace Files : 4
Path Health Checking : on(30)
Auto Failback : on(1)
Remove LU : off
Intermittent Error Monitor : off
HDLM Manager Ver WakeupTime
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss
HDLM Alert Driver Ver WakeupTime ElogMem Size
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss 128
HDLM Driver Ver WakeupTime
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss
License Type Expiration
Permanent -
KAPL01001-I The HDLM command completed normally. Operation
name = view, completion time = yyyy/mm/dd hh:mm:ss