HP Hitachi Dynamic Link Manager Software - Manual (Page 148)

3. Creating an HDLM Environment
124
Number Of Elog Files : 2
Trace Level : 0
Trace File Size(KB) : 1000
Number Of Trace Files : 4
Path Health Checking : on(30)
Auto Failback : on(1)
Remove LU : off
Intermittent Error Monitor : off
HDLM Manager Ver WakeupTime
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss
HDLM Alert Driver Ver WakeupTime ElogMem Size
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss 128
HDLM Driver Ver WakeupTime
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss
License Type Expiration
Permanent -
KAPL01001-I The HDLM command completed normally. Operation
name = view, completion time = yyyy/mm/dd hh:mm:ss
21. Use the results of the
view
operation to check the version of the installed HDLM.
If
x.x.x-xx
is displayed in
HDLM Version
, the correct version of HDLM has
been installed.
22. Use the results of the
view
operation to check that the programs are running
properly.
If
HDLM Manager
,
HDLM Alert Driver
, and
HDLM Driver
are all
Alive
, all
the programs are running correctly.
23. Check the path information as described in 3.6 Checking the Path Configuration,
and make sure that you have successfully installed HDLM in a single-path
configuration.
24. Connect cables to all the HBAs to change the configuration to a multi-path
configuration.
Figure 3-4: Single Path Configuration and Multi-path Configuration shows a
single path configuration and a multi-path configuration.