HP Hitachi Dynamic Link Manager Software - Manual (Page 180)

3. Creating an HDLM Environment
156
The value you specify here will apply to n in
program-installation-destination-drive
:\Program
Files\HITACHI\HNTRLib2\spool\Hntr2
n
.log
(n indicates a file number).
3. In File Size(KB), change the size of an integrated trace file.
The default is
256
(kilobytes). You can specify a value from 8 to 8192. Specify a
value greater than or equal to the setting of Buffer Size(KB).
4. In Buffer Size(KB), change the buffer size.
Change the buffer size for the monitoring cycle.
The default is
64
(kilobytes). You can specify a value from 8 to 2048. Specify a
value smaller than or equal to the setting of File Size(KB).
5. In Interval Timer(Sec), enter a value to shorten the monitoring cycle.
The default is
10
(seconds). You can specify a value from 1 to 300.
6. In Lookout Span(Sec), enter a value to specify the interval for monitoring the
number of messages to be output to the integrated trace file.
The default is
0
(seconds). You can specify a value from 0 to 3600.
If you specify
0
, you cannot adjust the number of messages to be output because
the system ignores the setting of Max Messages / Span.
7. In Max Messages / Span, enter a value to specify the maximum number of
messages to be output to the integrated trace file at the monitoring interval
specified in Lookout Span(Sec).
The default is
0
. You can specify a value from 0 to 500.
If you specify
0
, you cannot adjust the number of messages to be output.
If you specify
0
for Lookout Span(Sec), you cannot adjust the number of
messages to be output because the system ignores the Max Messages / Span
setting.
8. After you finish changing the settings, click the OK button.
The dialog box closes.
9. Close all of the Hitachi program products that are using Hitachi Network
Objectplaza Trace Library, or restart the host.
If you choose to restart the host, you do not need to perform step 10.
10. Restart the services of the HDLM manager and Hitachi Network Objectplaza
Trace Library for the Hitachi Network Objectplaza Trace Library settings to take
effect.
From Control Panel, choose Administrative Tools and then Services to open