HP Hitachi Dynamic Link Manager Software - Manual (Page 134)

3. Creating an HDLM Environment
110
If
HDLM Manager
,
HDLM Alert Driver
, and
HDLM Driver
are all
Alive
,
all the programs are running correctly.
24. After the installation finishes, check the path information as described in
3.6 Checking the Path Configuration, and make sure that you have successfully
installed HDLM in a single-path configuration.
25. Connect cables to all the HBAs to change the configuration to a multi-path
configuration.
26. Check the path information as described in 3.6 Checking the Path Configuration
to make sure that you have successfully assembled a multi-path configuration.
(3) When VCS Is Used
To install HDLM when VCS is used:
1.
Start each host.
Start them in a single-path configuration.
2. Use the VCS Configuration Wizard to configure the Cluster components.
3. Restart the hosts.
4. Log on to Windows as a member of the Administrators group.
5. Stop VCS.
6. Save the license key file directly under the Windows installation-destination
drive.
Also, instead of using the license key file, you can directly specify the license key
during the installation of HDLM.
installation-drive
:\hdlm_license
The license key file will be deleted after the installation finishes.
7. Perform the installation.
• If you are not performing an unattended installation, insert the DVD into the
drive and run the installation program
setup.exe
.
The program checks whether HDLM has already been installed. If HDLM
5.4 or earlier has been installed, the KAPL09129-E message will appear. If
this happens, carry out the procedure shown in 3.5.6 Migrating from HDLM
5.4 or Earlier to HDLM 5.5 or Later. If HDLM 5.5 or later has been
installed, the KAPL09173-W message will appear. If this happens, carry out
the procedure shown in 3.5.5 Upgrade Installation or Re-installation of