HP Hitachi Dynamic Link Manager Software - Manual (Page 138)

3. Creating an HDLM Environment
114
Number Of Elog Files : 2
Trace Level : 0
Trace File Size(KB) : 1000
Number Of Trace Files : 4
Path Health Checking : on(30)
Auto Failback : on(1)
Remove LU : off
Intermittent Error Monitor : off
HDLM Manager Ver WakeupTime
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss
HDLM Alert Driver Ver WakeupTime ElogMem Size
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss 128
HDLM Driver Ver WakeupTime
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss
License Type Expiration
Permanent -
KAPL01001-I The HDLM command completed normally. Operation
name = view, completion time = yyyy/mm/dd hh:mm:ss
Even if you are using VCS,
off
appears for
Support Cluster
. Even if this is
the case, the cluster support function will run properly.
22. Use the results of the
view
operation to check the version of the installed HDLM.
If
x.x.x-xx
is displayed in
HDLM Version
, the correct version of HDLM has
been installed.
23. Use the results of the
view
operation to check that the programs are running
properly.
If
HDLM Manager
,
HDLM Alert Driver
, and
HDLM Driver
are all
Alive
,
all the programs are running correctly.
24. After the installation finishes, check the path information as described in
3.6 Checking the Path Configuration, and make sure that you have successfully
installed HDLM in a single-path configuration.
25. Connect cables to all the HBAs to change the configuration to a multi-path
configuration.
26. Check the path information as described in 3.6 Checking the Path Configuration
to make sure that you have successfully assembled a multi-path configuration.
(4) When Oracle RAC Is Used
To install HDLM when Oracle RAC is used:
1.
Shut down all the hosts.
2. Make sure that all the hosts that make up the cluster system have been fully shut