HP Hitachi Dynamic Link Manager Software - Manual (Page 176)

3. Creating an HDLM Environment
152
This example shows how to enable the collection of audit log data:
>dlnkmgr set -audlog on -audlv 6 -category all
Specify
on
if you want to collect audit log data, and
off
if you do not want to collect
audit log data. If you specify
on
, you can use the
-audlv
parameter to specify the
collection level for audit log data and the
-category
parameter to specify the audit
log categories.
3.7.3 Checking the Updated Settings
This chapter describes how to check the updated settings by using the
dlnkmgr
command's
set
operation after settings have been changed.
When you change some settings, you can display information about all of HDLM
function settings. The following shows an example of executing the command:
>dlnkmgr view -sys -sfunc
HDLM Version : x.x.x-xx
Service Pack Version :
Load Balance : on(extended lio)
Support Cluster : off
Elog Level : 2
Elog File Size(KB) : 1000
Number Of Elog Files : 5
Trace Level : 1
Trace File Size(KB) : 2000
Number Of Trace Files : 10
Path Health Checking : on(10)
Auto Failback : on(10)
Remove LU : on
Intermittent Error Monitor : on(2/20)
KAPL01001-I The HDLM command completed normally. Operation name
= view, completion time = yyyy/mm/dd hh:mm:ss
>
After you have set up the collection of audit log data, use the following command to
make sure that the setting has been specified correctly:
ca
Audit log events of the
ConfigurationAccess
category are collected.
all
Audit log events of the
StartStop
,
Authentication
, and
ConfigurationAccess
categories are all collected.
Value Explanation