HP Hitachi Dynamic Link Manager Software - Manual (Page 387)

8. Messages
363
Details
HDLM manager could not start normally because some of the definitions in the
option definition file were invalid.
Action
If the KAPL04033-W message is output after this message, execute the
dlnkmgr
view -sys -sfunc
command, and then check the option settings.
Use the
dlnkmgr set
operation to return options settings back to where you had
them.
If the KAPL04033-W message is not output, restart HDLM manager.
If the same error occurs, re-install HDLM. For details on the
view
operation, see
6.7 view (Displays Information). For details on the
set
operation, see 6.6 set
(Sets Up the Operating Environment).
KAPL04010-E
Could not open the error log file.
Details
HDLM manager could not start normally because it was unable to open the error
log file.
Action
Check whether another program is currently using the error log file (for example,
the file is being opened in a text editor), or whether the error log file has been
inadvertently deleted.
KAPL04011-E
Could not output the error log file.
Details
The log information could not be output to the error log file.
Action
Make sure that the disk has enough unused capacity.
KAPL04012-E
Could not create a communication pipe. RC =
aa...aa
Details
HDLM manager could not start normally because it was unable to create a pipe
file, which is used in communication with HDLM commands.
aa...aa: OS error code (decimal (base-10) number)
Action