HP Hitachi Dynamic Link Manager Software - Manual (Page 147)

3. Creating an HDLM Environment
123
Enter five single-byte spaces between
DGC
and
RAID
.
14. Click the OK button to close the MPIO Properties dialog box.
15. Shut down the host.
Leave the host in a single-path configuration until you check (in step 23) whether
HDLM has been successfully installed.
16. Modify the storage system settings.
Modify the storage system settings by following the procedure described in the
maintenance documentation for that particular storage system.
17. Start the host.
18. Log on to Windows again as a member of the Administrators group.
19. Check the log file and PRSV key.
This step is unnecessary if you have performed step 9. In this case, go to step 20.
If you installed HDLM by performing an unattended installation and specified
y
for the
restart
key in the installation-information settings file, make sure that
the KAPL09181-I message is output to
installhdlm.log
. For details about
this log file, see (2) Notes on an Unattended Installation in 3.5.2 Preparations
for Installing HDLM by Performing an Unattended Installation and 7.7.4 About
the Log File in 7.7 The installhdlm Utility for Installing HDLM.
Make sure that the PRSV key displayed by the
dlmprsvkey
utility is unique
among all the other hosts in the SAN. If the PRSV key is not unique or is not
registered, or if the KAPL09131-W message appears, execute the
dlmprsvkey
utility with the
-r
parameter specified to re-register the PRSV key. If the PRSV
key is unregistered, HDLM functions might not properly operate. For details
about the
dlmprsvkey
utility, see 7.4 The dlmprsvkey Utility for Registering an
HDLM Persistent Reservation Key. If you used a license key file, it will be deleted
after the installation finishes. The KAPL09115-W message will appear if deletion
of this file fails. If this happens, delete the file manually.
20. Execute the
dlnkmgr
command's
view
operation to display the status of each
program.
An example of executing the
dlnkmgr
command's
view
operation is as follows:
>dlnkmgr view -sys
HDLM Version : x.x.x-xx
Service Pack Version :
Load Balance : on(extended lio)
Support Cluster : off
Elog Level : 3
Elog File Size (KB) : 9900