HP Hitachi Dynamic Link Manager Software - Manual (Page 157)

3. Creating an HDLM Environment
133
21. Restart each host.
22. Log on to Windows again as a member of the Administrators group.
23. Execute the
dlnkmgr
command's
view
operation to display the status of each
program.
Make sure that
on MSCS
is displayed in
Support Cluster
. An example of
executing the
dlnkmgr
command's
view
operation is as follows:
>dlnkmgr view -sys
HDLM Version : x.x.x-xx
Service Pack Version :
Load Balance : on(extended lio)
Support Cluster : on MSCS
Elog Level : 3
Elog File Size (KB) : 9900
Number Of Elog Files : 2
Trace Level : 0
Trace File Size(KB) : 1000
Number Of Trace Files : 4
Path Health Checking : on(30)
Auto Failback : on(1)
Remove LU : off
Intermittent Error Monitor : off
HDLM Manager Ver WakeupTime
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss
HDLM Alert Driver Ver WakeupTime ElogMem Size
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss 128
HDLM Driver Ver WakeupTime
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss
License Type Expiration
Permanent -
KAPL01001-I The HDLM command completed normally. Operation
name = view, completion time = yyyy/mm/dd hh:mm:ss
24. Use the results of the
view
operation to check the version of the installed HDLM.
If
x.x.x-xx
is displayed in
HDLM Version
, the correct version of HDLM has
been installed.
25. Use the results of the
view
operation to check that the programs are running
properly.
If
HDLM Manager
,
HDLM Alert Driver
, and
HDLM Driver
are all
Alive
,
all the programs are running correctly.
26. After the installation finishes, check the path information as described in