HP StorageWorks 2.12 Edge Switch - Manual (Page 64)

Monitoring and Managing the Switch
64 Edge Switch Element Manager User Guide
■ Operating Speed—Displays the current data speed for the port as 1 Gig , 2
Gig , or Not Established . Not Established displays if Negotiate
was set for the port through the Configure Ports dialog box and the data speed
has not been resolved between the port and the attached device, or if the port
and device are not communicating.
■ Port WWN—The port’s 16-digit World Wide Name (WWN).
■ Attached Port WWN—The WWN of the node logged into the port.
■ Block Configuration—Blocked or unblocked. Operation can be blocked or
unblocked using any of the following methods:
— Through the Configure Ports dialog box. See “ Configuring Ports ” on
page 115 for instructions.
— Right-click a port in the Hardware View, a port’s row in the Port List
View, or a port bar graph in the Performance View, and click Block Port.
— Click Product > Port > Block Port. This option is available from the
Hardware View, the Port List View, or the Performance View.
■ 10-100 km Configuration—Extended distance buffering. This can be
enabled or disabled for the port through the Configure Ports dialog box. See
“
Configuring Ports ” on page 115 for instructions.
■ LIN Alerts Configuration—This field indicates whether LIN alerts are
enabled or disabled. LIN alerts can be configured through the Configure Ports
dialog box. The default is for the LIN alerts to be enabled.
■ FAN Configuration—Indicates whether Fabric Address Notification (FAN)
is On or Off when the port is operating as an FL_Port.
■ Beaconing—This field indicates the beaconing status for the port. To enable
or disable beaconing, right-click the port and click Enable Beaconing. (A
port in a failed state cannot be set to beacon.)
■ Link Incident—Description of the last link incident that occurred on the port.
■ Operational State—Beaconing, Inactive, Invalid Attachment, Link Incident,
Link Reset, No Light, Not Operational, Online, Offline, Port Failure,
Segmented E_port, Testing, Or Not Installed. See
Table 4 on page 93 for
definitions of operational states.