HP StorageWorks 2.12 Edge Switch - Manual (Page 119)

Configuring the Switch
119 Edge Switch Element Manager User Guide
10. Use the scroll bar on the right side of the Configure Ports dialog box table to
display additional ports that you want to configure.
11. Activate changes and close the dialog box by clicking Activate.
12. If you are finished configuring the switch, back up the configuration data. For
more information, see “ Backup and Restore Configuration ” on page 168.
Configure Ports Procedure (Open Systems Management Style)
Note: This procedure applies only to the Edge Switch 2/32. Open Systems
Management Style (OSMS) is not available on the Edge Switch 2/24.
To configure Edge Switch 2/32 ports in Open Systems management style, use the
following steps:
1. Click Configure > Ports. The Configure Ports dialog box displays.
Figure 32: Configure Ports dialog box (Open Systems Management Style)
Ports are numbered from 0 through 31.
2. Click a Name field and type a name that reflects the end device connected
through the port. For example, use XYZ Server , where XYZ is the brand
name of the server.