HP StorageWorks 2.12 Edge Switch - Manual (Page 135)

Configuring the Switch
135 Edge Switch Element Manager User Guide
Configuring Date and Time
Use the procedures in this section to display and change the date and time set on
the switch. You must set the current date and time on the switch using this dialog
box so that the correct time stamps display in the Event Log, Audit Log, Hardware
Log, Link Incident Log, and Threshold Alerts Log.
Set the switch date and time using the following steps:
1. Click Configure > Date/Time. The Configure Date and Time dialog box
displays, as shown in Figure 41 .
Figure 41: Configure Date and Time dialog box
2. You can set the switch date and time manually or you can set it for periodic
synchronization with the HAFM appliance. For specific instructions, see the
following sections:
■ “ Setting Date and Time Manually ”
■ “ Synchronizing Date and Time ”
Setting Date and Time Manually
Use these steps to set the switch date and time manually.
1. At the Configure Date and Time dialog box, click the Periodic Date/Time
Synchronization check box to deselect the option (no check mark in the box).
The grayed-out Date and Time fields activate, as shown in
Figure 42: Configure Date and Time dialog box (Manual options)