HP StorageWorks 2.12 Edge Switch - Manual (Page 171)

Using Maintenance Features
171 Edge Switch Element Manager User Guide
Note: If you have enabled the Full Volatility feature through the switch's maintenance
port since the switch was shipped from the factory, this feature will be disabled (factory
default) when the configuration is reset.
Note: Factory default values may vary, depending on the firmware release installed in
your switch. For a list of values, refer to the appropriate service manual for your Edge
Switch.
3. Click Reset to reset all configuration data.
Note: If you have changed the switch‘s IP addressing from the factory default value,
you may not recover the Ethernet connection between the switch and the HAFM
appliance because the Internet Protocol (IP) address will reset to the factory default
during this procedure.
For complete steps in recovering this connection, refer to the Reset Configuration Data
procedure for the Element Manager in the appropriate service manual for your Edge
Switch.