HP StorageWorks 2.12 Edge Switch - Manual (Page 232)

Information and Error Messages
232 Error Messages
Open Trunking is not
installed for this
product. Please contact
your sales
representative.
The Open Trunking
feature key has not
been enabled. This
message only displays
if the optional Open
Trunking feature is
installed.
Enter the feature key into the
Configure Feature Key dialog
box and enable the key. If you
require a feature key, see your
account representative.
Performing this
operation will change
the current state to
Offline.
This message requests
confirmation to set the
director offline.
Click OK to set the director
offline or click Cancel to cancel
the operation.
Performing this
operation will change
the current state to
Online.
This message requests
confirmation to set the
director online.
Click OK to set the director
online or click Cancel to cancel
the operation.
Performing this action
will overwrite the
date/time on the
switch.
Warning that occurs
when configuring the
date and time through
the Configure Date
and Time dialog box,
that the new time or
date will overwrite the
existing time or date
set for the director or
switch.
Verify that you want to
overwrite the current date or
time.
Periodic Date/Time
synchronization must
be cleared.
Action cannot be
performed because
Periodic Date/Time
Synchronization option
is active.
Click Periodic Date/Time
Synchronization check box in
Configure Date and Time
dialog box (Configure menu) to
clear check mark and disable
periodic date/time
synchronization.
Port binding was
removed from attached
devices that are also
participating in Switch
Binding.
Informational
message. You removed
Port Binding from
attached devices, but
one or more of these
devices is still
controlled by Fabric
Binding.
Review the Switch Binding
Membership List to determine if
the devices should be members.
Table 8: Element Manager Messages (Continued)
Message Description Action